• Novus #3 8 oz

  • $10.99

  • Share this product

Description

Power Buffer

If the damaged area is fairly large or badly damaged, a power buffer may be used with NOVUS No. 2 and No. 3. Use a clean cotton bonnet and operate the buffer at a low speed to avoid overheating the plastic, approximately 1,000 RPM. Each polish should be applied with a separate, clean bonnet.

Before Polishing

Before attempting to clean or remove scratches, always make sure the plastic is cool to the touch. Use a liberal amount of plastic cleaner to safely remove surface dust and dirt. In addition, test scratch removers in a small or inconspicuous area for compatibility.

Coated Plastics

Some plastics are coated with a thin film which may be damaged by the abrasives in the polish. NOVUS No. 2 and No. 3 Polishes are not recommended for use on coated plastics or eyeglass lenses.

Polishing Cloth

The type of polishing cloth you use will make a difference. The ideal cloth is nonabrasive, absorbent and lint free. To eliminate any chance of scratching, use only disposable cloths. Reusable cloths can retain abrasive particles, but you won't know for sure until the damage is done. Use a soft cotton cloth (such as a diaper), avoid using polyester or rayon wipes which can scratch unprotected plastics.

 

HEAVY SCRATCH REMOVER

  • Removes heavy scratches and abrasions from most acrylic surfaces. Use when damage is too severe to be restored with NOVUS No. 2 polish.
  • Requires use of NOVUS No. 2 for final finishing
  • Not recommended for use on coated plastics

Directions:

  1. Shake well. Test in an inconspicuous area.
  2. Apply NOVUS No. 3 liberally. Using a clean, soft cloth, polish with a firm back-and-forth motion at right angles to the scratches. Keep the cloth saturated with polish at all times.
  3. Continue polishing until only fine scratches remain. Using cloth, remove all remaining polish, this is very important!
  4. Using a clean cloth, apply NOVUS No. 2 in a circular motion uniformly to entire surface. Polish using light pressure until NOVUS No. 2 dries to a light haze.
  5. Using a clean portion of the cloth, buff the surface clean. Follow with NOVUS No. 1 for best results.